Skip to contentBlack Friday20% off Lite and Core, 35% off Pro · until 30 NovemberSee prices
CAGE MOLD

Calculator

How much silicone do you need?

For a block mold poured in a rectangular box: type in the model's size and the silicone round it. The sums run on this page; nothing is sent anywhere.

Model
mm
mm
mm
ml

If you know it (your slicer or Blender tells you). Left empty, it is estimated from the shape below.

Silicone
mm
mm
g/ml
%
%
Casting material

Result

Silicone to mix

802 g

Base

786.06 g

Catalyst

15.72 g

Demold: 8 h

The box's inside
880 ml
The model's volume (estimate)
216 ml
Silicone volume
664 ml
For one cast
194 g

How it counts

The box's inside is the model's size plus the silicone on both sides: (X + 2 × side) × (Y + 2 × side) × (Z + top). The model stands on the box's floor, so there is no silicone under it. The silicone's volume is that inside less the model's own volume.

The weight is the volume times the silicone's density. Most mold silicones lie between 1.05 and 1.30 g/ml; the exact figure is on the product's data sheet. About 5 % extra covers what stays in the cup and on the stirrer. A and B are the total split by the mix ratio.

The casting material is the model's volume times the material's density. Wax shrinks as it cools; melt a little more to top up the reservoir.

Where do I find the model's volume?

  • PrusaSlicer and Bambu Studio show a selected model's volume in its object information.
  • In Blender, the 3D Print Toolbox extension gives the volume.
  • For a real object, sink it in a full container of water and weigh the water that overflows (1 g of water is 1 ml).

A box that follows the model instead of a block

In a block mold the corners fill with silicone. When the box follows the model at a set distance, the silicone stays equally thick everywhere and usually far less is needed than for a block. Its volume has no rectangular formula; it depends on the model's shape.

The surest way to measure it: fill the empty box, with the model inside, with water and weigh the water. Its grams are the volume in ml; multiply by the silicone's density.

Cage Mold (Core and Pro) shows the silicone of the mold it builds in grams with its A/B shares and prints the weight on the box's foot. Lite shows no grams; use the water method above.

More guides →